Embedded System Using 8051 MCU


ISO Certification Course on Design of Embedded System using 8051 MCU

Course Duation:5T+30P=35hrs

Theory Concepts:

  • Introduction to 8051
  • Introduction to Keil version 5
  • Introduction to Proteus 8
  • Introduction to 8051 ISP programmer
  • Features of AT89S52
  • Architecture, Pin Diagram
  • Memory Organization
  • Instruction set
  • I/O Ports Configuration
  • Analog To Digital Converter (ADC)
  • Timers Timer0,1 and 2
  • Capture Compare PWM Module (CCP)
  • UART Communications
  • Interrupts(Software and Hardware)
  • MSSP ( SPI and I2C)

Practical Session:

  • Interfacing LED(Light Emitting Diode)
  • Interfacing Switch with LED
  • Interfacing 7-Segment Display
  • Interfacing 7-Segment Display with Switch
  • Interfacing Relay with Switch
  • Interfacing LCD(16×2) in 8 bit mode and 4 bit mode
  • Interfacing LCD with Switch
  • Interfacing Stop Watch with LCD
  • Interfacing EEPROM to Read and Write the data
  • Interfacing PWM with LED
  • Interfacing I2C with LCD to Display RTC
  • Interfacing ADC with Sensor(Pot 10k,LM35,Proximity)
  • Interfacing Stepper Motor with Forward and Reverse Rotation using L298 Driver.
  • Interfacing DC Motor with Forward and Reverse Rotation using L298 Driver
  • Interfacing Matrix Keypad(4×4) with LCD
  • Interfacing UART with both Transmit and Receive
  • Interfacing GSM(SIM900A) to send a message
  • Interfacing RF(Radio Frequencies 433MHZ) to Wireless Communication

Course Highlights:

  • We will provide development board at free of cost
  • Industrial Trainers
  • Case study
  • Hands-On Training
  • Project Guidance
  • Tutorial and necessary documents
  • Compiler and Simulator student version


Any Diploma / BE (ECE, EEE, CSE, E&I), MSc (Electronics), and also to Industrial peoples etc.

Instant Callback !