ISO Certification Course on Design of Embedded System using Arduino UNO R3

Course Duation:5T+35P=40hrs

Theory Concepts:

• Introduction to Arduino UNO R3
• Introduction to Arduino Software
• Features of Arduino UNO R3
• Architecture, Pin Diagram
• Memory Organization
• Instruction set
• I/O Ports Configuration
• Analog To Digital Converter (ADC)
• Capture Compare PWM Module (CCP)
• UART Communications
• MSSP ( SPI and I2C)
• I2C RTC & SPI EEPROM

Practical Session:

• Interfacing LED(Light Emitting Diode)
• Interfacing Switch with LED
• Interfacing 7-Segment Display
• Interfacing 7-Segment Display with Switch
• Interfacing Relay with Switch
• Interfacing LCD(16×2) in 8 bit mode and 4 bit mode
• Interfacing LCD with Switch
• Interfacing Stop Watch with LCD
• Interfacing EEPROM to Read and Write the data
• Interfacing PWM with LED
• Interfacing I2C with LCD to Display RTC
• Interfacing ADC with Sensor(Pot 10k,LM35,Proximity)
• Interfacing Stepper Motor with Forward and Reverse Rotation using L298 Driver.
• Interfacing DC Motor with Forward and Reverse Rotation using L298 Driver
• Interfacing Matrix Keypad(4×4) with LCD
• Interfacing UART with both Transmit and Receive
• Interfacing GSM(SIM900A) to send a message
• Interfacing RF(Radio Frequencies 433MHZ) to Wireless Communication

Course Highlights:

• We will provide development board at free of cost
• Industrial Trainers
• Case study
• Hands-On Training
• Project Guidance
• Tutorial and necessary documents
• Compiler and Simulator student version